Corrections

ALL PATTERN CORRECTIONS HERE ARE FOR PRINTED PATTERNS, DOWNLOADS HAVE BEEN CORRECTED.

If you have found a mistake, please let us know. While we try very hard on occasion we still miss something.

Thank you for your understanding!

 

WITCH PLEASE
DOWNLOADABLE PATTERN IS CORRECT 
Cutting Fabric A, it is the “Witch” background, not snowman :)
Step 4: the 6 1/2 x 30 1/2 inch rectangle is Fabric B, not G.
All references to the Wall Hanging Diagram are page 4 not 5.


CORRECTION FOR BY THE SHORE
DOWNLOADABLE PATTERN IS CORRECT
Fabric E
Cut three strips 5 inches, sub-cut (22) 5 x 5 inch squares for the HST and four patch units. 
Fabric F
Cut one strip 8 7/8 inches, sub-cut (4) 8 7/8 x 8 7/8 inch squares for the quilt center, then cut in half on the diagonal.
 STEP 1:  Appliqué Corners
Take an 8 7/8 inch HST’s cut from Fabric E  and sew it to HST of Fabric F as shown in Figure 1a.
 
CORRECTION FOR SILENT NIGHT
DOWNLOADABLE PATTERN IS CORRECT
Backing fabric of choice 2 2/3 yards 44 inches wide or 1 3/8 of 90 inch.
Batting 2 2/3 yards  44 inch wide or 1 3/8 of 90 inch.
STEP 3:

  • Take one 3 1/2 x 5 inch piece of Fabric D part (O) and both  2 3/4 x 3 1/2 pieces of Fabric K part (P).  Lay one part P on the part O, right sides together (RST) as shown in Figure 3a.  Turn part P one turn to the left and place the far corner on the top  edge of part O as shown, draw a line from corner to corner.
  • Sew on the line then trim  1/4 inch from the seam.
  • Press open, repeat on the other side with the other part P.


 
JUST DUCKY PATTERN CORRECTIONS
Corrections for cutting parts.
Fabric C
Cut one strip 5 1/2 inches, sub-cut two 5 1/2 x 10 1/2 rectangles (C1).
Fabric J
Cut one strip 6 1/2 inches, sub-cut two 6 1/2 x 5 1/2 inch rectangles (J1) and 
two 2 1/2 x 5 1/2 inch rectangles (J3).
(from the strip cut) two 2 1/2 x 4 1/2 inch rectangles (J12) and two 2 1/2 x 3 1/2 inch rectangles (this part becomes J12b).  
Fabric L
Cut one strip 2 inches, sub-cut two 1 1/2 x 1 1/2 inch squares (L1). 
Cut one strip 4 1/2 inches, sub-cut two 3 1/2 x 4 1/2 inch squares (M1).  


POSY POPS PATTERN CORRECTIONS
While formatting for printing we accidentally cut off the fabric listed for Fabric J on the pattern back. It is as follows:
Fabric J - Red dots on pink 1/8 yard
Block
Moda Beautiful Day 29137-29

INTO THE WOODS PATTERN CORRECTIONS
Cutting Corrections
FABRIC C (This fabric is directional) From the WOF (width of fabric), cut five strips 1 1/2 inches, sub-cut three pieces 1 1/2 x 32 1/2 inches, two pieces 1 1/2 x 34 1/2 inches. From the remainder, cutting from the LOF (length of fabric), cut three strips 1 1/2 inches then sub-cut two strips 1 1/2 x 28 1/2 inches and one strip to two 1 1/2 x 15 1/2 inches. These are for sashing and border 1. Cut seven strips 2 inches for the binding. From remaining WOF, cut one strip 10 1/2 inches, sub-cut eight 1 1/2 x 10 1/2 inch pieces.
FABRIC I part I4 one piece 6 1/4 x 2 5/8 inches.
FABRIC K Cut two strips 1 inch then sub-cut: BK 1/3 four pieces 1 x 9 1/2 inches. BK 1/3 four pieces 1 x 10 1/2 inches.
FABRIC N part N24 two pieces 1 1/2 x 7 inches.
Border Corrections
Border 2: Pieces needed:Fabric A, two 4 1/2 x 40 1/2 inch pieces, two 4 1/2 x 34 1/2 inches and two 4 1/2 x 5 1/2 inch pieces. Fabric L, four 4 1/2 x 4 1/2 inch squares for the corners. Sashing and Border 1: Start by sewing the 1 1/2 x 10 1/2 inch strips of Fabric C between each of the blocks as shown below in Figure 4a. Note the direction of the fabric and the placement of each animal and quilt block. When the rows are completed, take the three 1 1/2 x 32 1/2 inch pieces of Fabric C and sew them between each row. Sew together one 1 1/2 x 28 1/2 inch and one 1 1/2 x 15 1/2 inch piece. Repeat with the last two pieces of each and sew one to each side of the quilt center. Sew a 1 1/2 x 34 1/2 inch piece to the top and one to the bottom of the quilt center.

GARDEN PARTY PATTERN CORRECTIONS
*All printed patterns with corrections will say REVISED OCTOBER 2021 on the pattern back.
CUTTING CHANGES:
Fabric I: C5 and C6 are actually I5 and I6 (that was an easy one).
Fabric G: Added part G3b, cut one 1 7/8 x 4 1/2 rectangle (bluejay) after cutting part G7 (was G3 in diagram of tail section) See figure 1a.
Change G8 to 1 1/2 x 4 inches.
Change G3 to cut one 2 x 4 1/2 inch rectangle.
Fabric M: Change M4 to 1 x 2 inches.
Fabric R: Change R1 to 2 5/8 x 2 5/8 inches.
Fabric P: Added part P16b (was P16 in diagram), cut one 2 5/8 x 2 5/8 inch square. This is the beak area of the Bluejay. See figure 1b.
Changed the dimensions/count of P33, cut four 1 7/8 x 1 7/8 inch squares. These parts are used for the Bluejay block.
P30 change to 2 1/2 x 5 inches.
P2 Change to 4 x 7 1/2 inches.


DIRECTION CHANGES:
Step 5 for the Bluejay block REVISED:
Cut one (R1) and (P15) square in half on the diagonal. Select one triangle from each square and sew together as shown in Figure 5a. Press open then take the G5 square and lay it over the top, RST and draw your diagonal line on the square and use the sew and flip method to create this part.
Step 7: for Four Patch blocks......third bullet point....Ooops! We only need to cut NINE pairs for the block.
Tool diagram: Figure 10a, handle part should be J1.
Step 12: Border 1. All Border 1 strip measurements should say 2 1/2 inches wide, cutting directions are correct.
Border 2 REVISED: (We somehow got edit happy and deleted the Border 2 corner instructions!)
Added third bullet point: Take the four M1 Pieces and sew one to the end of each of the top and bottom borders.
Click HERE to download a PDF of the corrections for Garden Party.

WOVEN PATTERN CORRECTION
Fabric B and D cutting, cut ELEVEN strips 2 1/2 inches, instead of four, then sub-cut into sixty-four 2 1/2 x 6 1/2 inch pieces.

CELEBRATE PATTERN CORRECTION
Fabric I cutting: It says Cut one strip 6 1/2 inches, sub-cut eight 4 x 6 1/2 inch rectangles for the Rocket Blocks. IT SHOULD SAY: Cut one strip 6 1/2 inches, sub-cut eight 4 1/2 x 6 1/2 inch rectangles for the Rocket Blocks.